Application
Example in which CODEC and Microcontroller are not on the same chip
Flash products are licensed from Silicon Storage Technology, Inc.,(USA), and manufactured and sold by SANYO Electric Co., Ltd.

Flash products are licensed from Silicon Storage Technology, Inc.,(USA), and manufactured and sold by SANYO Electric Co., Ltd.
Memory capacity:
Flash ROM 128K×8 bits (on-board programable)
RAM 8,192×9 bits
Supply voltage: VDD= 2.7 to 3.6 V
USB interface (Ver.1.1, full speed version)
Provides 7 endpoints
Multiply/divide instructions: 24×16, 24/16, 16×8, 16/8
Serial I/O circuit with 32-byte automatic transfer function
Remote controller signal receiver circuit
Package: TQFP64J/TQFP48J/QIP48E
These revolutionary devices are self-contained FM radio ICs that require no external components.
FM+source selector+ headphone amplifier Ultraminiature package: VQLP40
For small product such as cell phones and other portable electronic devices.
Supports MP3, AAC, and AAC+.
On-chip 32-bit microcontroller (ARM7TDMI®)
Ultralow power consumption: 10 mW
Achieves the ultralow power consumption that is extremely difficult for DSP-based implementations (measured power consumption : 15 mW)
Supports a wide range of sampling rates
MPEG1 (32, 44.1, and 48 kHz)
MPEG2 (16, 22.05, and 24 kHz)
MPEG2.5 (8, 11.025, and 12 kHz)
On-chip ΔΣ D/A converter
Supports use of an external D/A converter
Digital volume and tone control circuits
Digital bass boost and audio leakage prevention circuits
(Only available when the internal D/A converter is used.)
CRC error soft muting function
Supports reading ancillary data
Sleep mode support
External oscillator frequency: 16.9344 MHz (44.1 kHz×384)
Package: SQFP64/FBGA96
Ultralow power (MP3: 10 mW, WMA: 15 mW)
Supported formats
• MPEG1, MPEG2, and MPEG2.5 (all sampling frequencies, all bit rates)
• WMA
Digital volume and tone control circuits
Digital equalizer and audio leakage prevention circuits (D/A converter)
ΔΣ D/A converter and class D amplifier
PCM I/O interface
Sleep mode
Crystal oscillator: 16.9344 MHz (44.1 kHz×384)
Built-in PLL circuit to support sampling frequencies other than 44.1 kHz
Supply voltages: Internal: 1.2 to 1.8 V, external: 2.7 to 3.6 V
Package: SQFP64
Data Sheet PDF
For LCD Backlights of Portable Electronic Devicess
LED Driver
LC41059
White LED driver that allows the brightness to be adjusted
Input voltage: 2.7 V to 5.5 V
Drives 1 to 4 LEDs at max. 100 mA (25 mA×4)
Supports brightness address over voltage input or pulse input
Power saving function
Soft start function (Overcurrent protection)
Package: VQFN28 W-CSP
Δ To top of page
Linkage